Now we need to separate the two access points. Go to Wireless -> Wireless Security and set up WPA. Leaving it bridged as such will allow you to set up WPA security on the new WLAN. Dd wrt v24 sp2 openvpn driver#Make sure you leave it bridged, there is a bug in Broadcoms proprietary driver that causes problems with unbridged VAPs. Go to your wireless tab and on the bottom of the page hit the "Add" Button under -Virtual Interfaces. You can verify connection in the Status -> OpenVPN tab. IMPORTANT: Make sure your VPN connects before moving on with this guide. and put the TAP interface created by OpenVPN on the same bridge as wl0.1. Follow these instructions until you get to the point where you assign wl0.1 to br1. If you need to use a TAP connection, set up is fairly simple. Under most circumstances you will not need the features of a bridged TAP connection. If you have a TAP interface the instructions below will not work for you. The following instructions are built around a TUN interface being set up by OpenVPN. (This will allow OpenVPN to set up the basic routing and iptables rules that you will need)Īlso, take note that TUN interfaces are for routing, and TAP interfaces are for bridging. ENSURE that route no-pull is NOT set in your additional config dialog. We need to define our own routes later.Ģ. ENSURE that redirect-gateway def1 is NOT set in your additional config dialog. Just a few things to make sure of here besides the default setup.ġ. Dd wrt v24 sp2 openvpn how to#I am not going to rewrite the entire guide on how to accomplish that, as it can be found here (for username/password auth) or here(for PKI). I was not successful in getting to work with OpenVPN on builds past 18946. If you get it running, please PM Vespian in the forums and let me know how it worked out for you so I can edit this guide. Note: This procedure was tested on an ASUS RT-N16 running DD-WRT v24-sp2 (12/08/11) big (SVN revision 17990M NEWD-2 K2.6 Eko) I have not tested this with PPTP. Provided that the GUI implementation of PPTP doesnt redirect your gateway through the tunnel, and PPTP in your version of DD-WRT functions. This guide was written with OpenVPN in mind, but it should work just as well for a PPTP tunnel. I will link to other sections of the Wiki where possible. This guide will walk you through the steps required to set up a Virtual Access Point (VAP) that is funneled through an OpenVPN tunnel, while the main access point is pushed through your normal WAN link provided by your ISP. Please consult the OpenVPN guides on the forum as they are more up-to-date until this wiki has been updated accordingly. Please note that this wiki is outdated and not applicable in current releases of DD-WRT.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |